Recon JK Front Bumpstop Mount Install Guide

REBEL OFF ROAD FRONT BUMPSTOP MOUNT INSTALLATION INSTRUCTIONS
Part# ROE-RECON-BKT-FBUMP
Includes: Front upper bumpstop mounts | Grade-8 hardware

Thank you for purchasing the Rebel Off Road bolt-on bumpstop kit. This system includes all necessary mounting brackets and hardware to convert the front of a Jeep Wrangler JK to a hydraulic bumpstop design. (Bumpstops sold separately / available from Rebel Off Road.) This system is engineered to achieve rock buggy caliber wheel travel when offroad plus superb street drivability when on pavement.

NOTE: For ease of installation, the bumpstop should be installed prior to mounting the bumpstop mounting bracket.

Installation – Bumpstop into Bumpstop Mount: NOTE: Instructions assume a King 2.0 bumpstop is used

Remove large nut on top of bumpstop and insert bumpstop into mount
Line up off center allen head locating bolt on bumpstop with off center hole in bumpstop mount
Tighten down large nut

Bumpstop Mount Install:

Begin with Driver’s side
Remove 3 nuts and 3 washers that secure upper coilover mount to factory coil spring bucket
Install bumpstop mount onto 3 bolts
Reinstall 3 nuts and 3 washers
Tighten all hardware
Follow same instructions on Passenger side

NOTE: The top of the bumpstop will protrude through the hole in the factory coil bucket.